Standard Wood Waterbed Frame Assembly

Spread your safety liner out in the frame. Smooth out all wrinkles particularly over the heating pad. Align all corners of the liner with the frame's corners.

Stand-Up Style

If you purchased a stand-up safety liner, it's simple to install. Spread it out and smooth out all wrinkles particularly over the heating pad.

Optional Duvet/Protective Cover

If you purchased an optional duvet, this is the point where it would be installed. Be sure that the manufacturers label is at the foot of the bed. Unfold the duvet and lay it out similar to the way the safety liner was laid out.

Unzip the duvet down both sides and lay it over the head of the bed. This allows easy access for installing the waterbed mattress(s). Smooth out the inside of the duvet.

Get Duvet Ready

Unzip the duvet (if applicable) on both sides and lay it over the head of the bed. This allows easy access for installing the waterbed mattress(s). Smooth out the inside of the duvet.

Take care with the zippers, too much stress and they will pull apart possibly causing damage.

Mattress

Lay out your waterbed mattress. Be sure the fill valve is at the foot of the mattress. Be careful not to shift the fiber layers inside the mattress as you maneuver it around. You also need to be sure the safety liner stays in place. Remove the wrinkles on the mattress bottom and center it.

Do not tape the safety liner to the frame, this often results in a ripped safety liner.

Aligning It Is Important

Gently align the corners of the mattress with the corners of the frame.

Check the heater, heater sensor tube, and safety liner for proper position before moving on to the next step.


Menu		Next

TEXT MENU

Step #	Action	Step #	Action
1	Sandbox Frame	3	Deck Assembly
1	Extended Frame	4	Frame Mounting
1	Poster Frame	5	Heater
2	Standard Riser	6	Liner and Mattress
2	Drawer Riser	7	Filling the Mattress